FCCライセンス 5月 24 2024 SUBELEMENT T2A SUBELEMENT T2A - OPERATING PROCEDURES T2A - Station operation: choosing an operating frequency, calling another station, test transmissions; Band plans: calling frequencies, repeater offsets 1 / 12 T2A01What is a common repeater frequency offset in the 2 meter band? A. Plus or minus 5 MHz B. Plus or minus 600 kHz C. Plus or minus 500 kHz D. Plus or minus 1 MHz 2 / 12 T2A02What is the national calling frequency for FM simplex operations in the 2 meter band? A. 146.520 MHz B. 145.000 MHz C. 432.100 MHz D. 446.000 MHz 3 / 12 T2A03What is a common repeater frequency offset in the 70 cm band? A. Plus or minus 5 MHz B. Plus or minus 600 kHz C. Plus or minus 500 kHz D. Plus or minus 1 MHz 4 / 12 T2A04What is an appropriate way to call another station on a repeater if you know the other station's call sign? A. Say "break, break," then say the station's call sign B. Say the station's call sign, then identify with your call sign C. Say "CQ" three times, then the other station's call sign D. Wait for the station to call CQ, then answer 5 / 12 T2A05How should you respond to a station calling CQ? A. Transmit "CQ" followed by the other station’s call sign B. Transmit your call sign followed by the other station’s call sign C. Transmit the other station’s call sign followed by your call sign D. Transmit a signal report followed by your call sign 6 / 12 T2A06Which of the following is required when making on-the-air test transmissions? A. Identify the transmitting station B. Conduct tests only between 10 p.m. and 6 a.m. local time C. Notify the FCC of the transmissions D. All these choices are correct 7 / 12 T2A07What is meant by "repeater offset”? A. The difference between a repeater’s transmit and receive frequencies B. The repeater has a time delay to prevent interference C. The repeater station identification is done on a separate frequency D. The number of simultaneous transmit frequencies used by a repeater 8 / 12 T2A08What is the meaning of the procedural signal “CQ”? A. Call on the quarter hour B. Test transmission, no reply expected C. Only the called station should transmit D. Calling any station 9 / 12 T2A09Which of the following indicates that a station is listening on a repeater and looking for a contact? A. “CQ CQ” followed by the repeater’s call sign B. The station’s call sign followed by the word “monitoring” C. The repeater call sign followed by the station’s call sign D. “QSY” followed by your call sign 10 / 12 T2A10What is a band plan, beyond the privileges established by the FCC? A. A voluntary guideline for using different modes or activities within an amateur band B. A list of operating schedules C. A list of available net frequencies D. A plan devised by a club to indicate frequency band usage 11 / 12 T2A11What term describes an amateur station that is transmitting and receiving on the same frequency? A. Full duplex B. Diplex C. Simplex D. Multiplex 12 / 12 T2A12 (D)What should you do before calling CQ? A. Listen first to be sure that no one else is using the frequency B. Ask if the frequency is in use C. Make sure you are authorized to use that frequency D. All these choices are correct Your score isThe average score is 0% 0% Restart quiz Ed 0 コメント
